CHECKBOOK COVER PATTERN LICENSE

It was a good decision it’s a good 1 1/2 – 2 inches thick when it’s folded up. I decided not to add a section for cash and change – partly because I have a purple coin purse I just love, and partly because I was worried about how thick it would be when folded with the three sections. I’ll have to experiment to figure out how fix that.

CHECKBOOK COVER PATTERN LICENSE

The driver’s license window is a bit wonky on the left too. It’s better than my first attempt, but still not perfect the credit card slots on the far right in both middle and top sections are too close to the outer edge, so next time I’ll either leave those out or move them all more towards the left. I was very proud to think of putting the driver’s license upside-down, so when I’m writing a check I don’t have to flip the checkbook cover around for the clerk to see. I’ve always carried the charts in my purse so I’d have them when I needed them.

The top section also has the driver’s license window and an opening at the bottom for the kids’ immunization records. My old checkbook cover didn’t have enough slots for the gazillions I usually have, which is why I added a third section to the new cover. The middle and top sections have lots of places for coupons, discount cards, photos, etc. The bottom section is the three sets of checks I usually carry with me one for the daycare, one for the diaper business and one for family stuff. Here’s what I ended up with – doesn’t it look great? Since this was my first attempt at a checkbook cover I didn’t take step-by-step photos to write a tutorial, but I did take a couple of photos when it was done. I cut a rectangle from the laminating film, basted it into the driver’s license window and voilà – good as new! Since I’d melted the original plastic I had to find another alternative and after thinking about it a while I remembered a length of laminating film I’d cut from a poster I’d had laminated a while ago. I remeasured, cut, pressed and sewed again, making the entire thing a little bigger. And I accidentally ironed over part of the driver’s license window and melted the plastic. I didn’t account for the space all those coupons, discount cards, photos and etc would use so it ended up too small. I liked the driver’s license “window” and pulled the plastic out to use in the new checkbook cover.Īfter measuring, cutting, pressing, and sewing the first attempt ended up being an epic failure.

I loved the basic design of my old checkbook cover but needed more space for coupons, discount cards, photos, etc, so I used the old one as a model. I had recently made myself a new purse so I decided to make a checkbook cover to match. When my beloved leather checkbook cover started looking like something the cat dragged in I knew it was time to get a new one.

Checkbook cover pattern